[problemloeser]

Zitat von Ghibli

Gratuliere!!



Das ist nicht notwendig. Die motoren sind einfache motoren die mann da einfach ausdrehen kann. Nach den einbau adjustiert das alles sichselbst.

Siehe auch WDS:
Position sensing
The current position of the eccentric shaft is sensed by a special position sensor. The engine management controls the position by means of the electric drive until the current position corresponds to the set position.

Learning function / adaptation
In order to achieve the correct valve opening height, all the tolerances in the valve gear must be balanced by an adaptation. In this learning procedure, there is a slow approach to the mechanical adjustment limits of the eccentric shaft. The positions thus reached are stored and used in each operating point as the basis for calculating the current valve stroke.

The learning procedure runs automatically if, for example after a repair, a difference between the last stop position and the new starting position (with terminal 15 on) is detected. The adaptation can also be requested via the DIS-plus Tester.

danke für die Info