http://www.7-forum.com/forum/24/dros...-e32-5321.html
http://www.e38.org/e32/M70info.pdf
http://www.europeantransmissions.com...MW/EML-BMW.pdf
von Seite 52
http://www1.snapon.com/display/DocMg...px?fileid=4653
Bosch EML for M70 and S70 Engines
This is the first, full drive-by-wire electronic throttle system (used in U.S. only on the 7 and 8 Series). On the V12, a separate control module called EML synchronizes and controls dual throttle valve assemblies called DKs.
Whenever power has been disconnected or EML components have been replaced, the EML system usually requires adaptation to synchronize and coordinate system components. Use the following throttle synchronization procedure for the M70 engine.
z To synchronize the EML throttle:
1. Disconnect the battery for at least 1 hour.
2. Connect the battery and start the engine. Let the engine reach operating temperature without touching the accelerator pedal.
3. With the transmission in first gear, accelerate until engine speed is over 5000 RPM.
4. Release the accelerator pedal and coast until engine is at idle.
5. Repeat the above operation two consecutive times.
Auf jeden Fall die Drosselklappen saeubern
http://www.mwrench.com/Whitepapers/DKMotorcleanup.pdf