Das Bentley Reparaturhandbuch sagt auf Seite 130-45 zu pedal position sensor checking, Bild zeigt den dicken Knubbel Nr. 1 in Richtung Scheibe linke Seite Motorraum, da sind ja von vorne, Diagnosebuchse und dann die 2 dicken X..., der erste von der Scheibe.
To check adjustment, peel back rubber boot from EML harness connector and connect digital voltmeter between specified pin in connector and ground.
M70 DME 1.2 brown/violet pin 1
M70 DME 1.7 blue/brown pin 20
terminal numbers are molded in the EML connector face.
Turn ignition on
check signal from pedal position sensor while moving accelerator pedal
EML pedal position sensor test
pedal at idle position, automatic transmission 0.35 - 0.45 VDC
pedal at full throttle , automatic transmission 3.7 - 3.8 VDC
Hier noch weitere Messwerte fuer die DME M1.2
http://www.europeantransmission.com/...out1988_90.pdf