das Werkstatthandbuch sagt: Donut/ cylinder identification M70, S70: Resistance at 3-pin connector. Measure plug between pin 1 + 2, ≤1 ohm, insulation resistance between pin 2 + 3: ≥ 10 MOhm
Donut-/Zylindererkennung M70, S70: Widerstand am 3-poligen Stecker: Stecker zwischen Pin 1 + 2 messen: ≤1 Ohm, Isolationswiderstand zwischen Pin 2 + 3: ≥ 10 MOhm.
Lage der Sensoren
https://www.bmw-rudel.de/index.php/b...toren&catid=12
Nr......Sensortyp................................. ........Ziel
1 KW-Sensor Bank 1................................DME1
2 KW-Sensor Bank 2................................DME2
3 Zylinderidentifikationssensor Bank 2.........DME2
4 Zylinderidentifikationssensor Bank 1.........DME1