Hello T bird.
Maybe you misunderstood. It's hard to explane. Try again.
I took the damaged flap ( valve ) out ouf the housing and repeared it so it wil fit on the square axel. But because of the damage the motor could freely turn around so now it's of it's position.
So when I re assemble the whole thing, I need to take the motor of and turn the arm from the gearbox to a default position so I can reattach the metal rod that operates the flap to the arm of the gearbox. But than I don't know the default position.
So my question. As I start the engine, how does the software know in which position the flap to not demage the whole thing again?
I hope I was clear this time.
Thanks. Henk.
|