[peterpaul]

Zitat von SALZPUCKEL

Hallo laafer

auf die schnelle gefunden http://www.7-forum.com/images/link_rot.gif  BC

Anschlüsse von III und IV sollten identisch sein

Gruß Wolfgang

Hallo Wolfgang!

Auf die Schnelle führt der Link zu SKF ....
"  SKF.com /  Produkte /  Interaktiver Lagerungskatalog /  Wellendichtungen / Wear sleeves SKF wear sleeves are available in two different designs, depending on size. One is the extremely thin-walled SKF SPEEDI-SLEEVE ( fig) which allows replacement seals of the same size as the original seals to be used. The SKF SPEEDI-SLEEVE is produced for shaft diameters up to and including 203 mm. For larger shafts, up to approximately 1 150 mm in diameter, SKF produces the LDSLV wear sleeves in two designs: the LDSLV3 ( fig) with flange, and the LDSLV4 ( fig) without flange."




Ich glaub nicht das Du das beabsichtigt hast.....



mfg
peter