Tag zusammen,
Wollte die Prozedur ich mal ausprobieren:
To review the FAULT CODES from the ECU memory use the following procedure:
1) Turn the ignition switch to the 'engine run' position.
2) Depress the gas pedal to the floor 5 times.
In the 12 cylinder model the Injection system is treated as two 6 cylinder systems joined at the crank. This means there
are two ECUs in the system. To access the second ECU depress the gas pedal to the floor 6 times.Some models will
return implausible blink codes if the ECU has failed or if the power is interrupted during operation. Removal of the
control units harness and reconnection after 10 minutes seems to resolve most of these problems.
Passiert bei mir aber gar nix; ist das echt nun ein guetes Zeichen und sind keine Fehler registriert?
Grüsse
Martin
|