siehe unten, Einstellung und Testen aus E32 Bentley Repair Manual Seite 130-45.
EML Pedal Position Sensor Test
pedal at idle position
manual transmission 0.34-0.43 VDC
automatic transmission 0.35-0.45 VDC
pedal at full throttle
manual transmission 3.1-3.3 VDC
automatic transmission 3.7-3.8 VDC
EML connector pedal position test pin
M70 DME 1.2 brown/violet pin 1
M70 DME 1.7 blue/brown pin 20
M30 DME 1.3 blue/brown pin 20
terminal numbers are molded in the EML connector face. These numbers are very small and may be difficult to read.
set a gap of 3mm / 0.118 in. between accelerator pedal bracket and the idle stop.
To check adjustment, peel back rubber boot from EML harness connector (round big plug left side engine bay close to the diagnosis port) and connect digital voltmeter between specified pin in connector and ground.
|