steht im Bentley Buch ausfuehrlich drin
pedal position sensor M30 and M70
checking and adjusting
loosen pedal position sensor arm retaining nut
set gap of 3 mm between accelerator pedal bracket and idle stop.
support arm and tighten nut. Idle position is now set.
Adjust pedal travel stop: press accel pedal down by hand until kickdown pressure point is felt.
EML connector pedal position test pin
engine room, the big round one next to the diagnosis box.
M30 (DME 1.3) blue/brown pin 20
terminal numbers are molded in the EML connector face. These numbers are very small and may be difficult to read.
Turn ignition on
check signal from pedal position sensor while moving accel pedal
EML Pedal Position Sensor Test
pedal at idle position
manual transmission 0.34-0.43 VDC
automatic trans 0.35-0.45 VDC
pedal at full throttle
manual trans 3.1-3.3 VDC
automatic trans 3.7-3.8 VDC
Drosselklappen messen steht bei mir auf der Seite unter
Reference data
|