in der E-box, wie in the kleinen Bild angegeben, ich kopier/schreib das hier noch mal:
Reinitializing ASC+T/ABS control module
The ABS/ASC+T system must be reinitialized if any of the following components has been disconnected or replaced.
-ABS/ASC+T hydraulic control unit
-Throttle valve assembly
-Throttle potentiometer
Disconnect ABS/ASC+T control module harness connector located in the E-box at right rear corner of engine compartment.
-Run engine for one minute, then shut-off
-Reattach ABS/ASC+T control module.
Siehe Bentley Buch Seite 340-36
|