Hier mal die Ausfuehrung von kibokojoe in USA basierend auf dieser Idee:
Ended up making my own locking bracket out of 0.032 brass plate. After I saw the picture of the ones made in Germany it was pretty easy. All I had to do besides the bracket was to make some compression washers out of aluminum on my lathe, that was pretty easy too. The thickness of the new washers and the brackets equals the thickness of the original washer. Didn't want anything obstructing those oil orifices. Anyway I have installed the banjo's, washers and brackets with high temp locktite. Torqued them to 96 inch pounds. I have looked that the cams on the shaft and there is no noticeable wear or flat spots. Thank God. Must have just happened. If anyone is interested I will post the dimension of the bracket. Not real difficult to make and you can be off a little and it will still fit nicely.
http://i273.photobucket.com/albums/j...rbanjobolt.jpg
http://i273.photobucket.com/albums/j...oltmounted.jpg
http://i273.photobucket.com/albums/j...tsidephoto.jpg
Hat auf meine Bitte noch eine Zeichnung gemacht, Zahlen in (...) sind mm
http://i273.photobucket.com/albums/j...etdrawing4.jpg